Clear ARP Information for an Interface
Clear the Address Resolution Protocol (ARP) cache as part of ARP problem resolution procedures.
Procedure
Example
Switch:1>enable Switch:1#clear ip arp interface gigabithethernet 1/1
Variable Definitions
The following table defines parameters for the clear ip arp interface command.
Variable |
Value |
---|---|
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} |
Identifies the
slot and port in one of the following formats:
|